Page Content
...
The “SC_Offline_User_Interface” subsystem consists of three areas, as shown in figure 2.
The green area (dynamometer Control) send the reference to the dynamometer.
The yellowarea (Signal Monitoring) is used for receiving and monitoring data from the OPAL-RT simulator.
The orange area (Instruction) provides important information about the model and its test procedure.
...
Launch RT-LAB.
Import project zip file (see below) in RT-LAB.
Build, load, and execute the model.
Turn on the 8540 dynamometer and, through its touch panel, enable its “Computer-Based Control,” as depicted in figure 5 below.
In this operating mode, the user can monitor the state of the dynamometer: torque, speed (frequency), current, and voltage.
...
Based on the preceding tests, the hardware and software included in Festo’s models are declared fully functional and compliant with OPAL-RT specifications.
| Anchor | ||||
|---|---|---|---|---|
|
Model (Zip File)
| Attachments | ||||
|---|---|---|---|---|
|
...