...
This model is based on PI-section. As shown in the figure below, there are two ports for current measurement.
...
Parameters
Symbol | Description | Unit |
|---|---|---|
ID | Line name | a unique name |
Status | Connect/Disconnect status | Initial value 1 (0 for disconnected) |
From bus | Sending bus | a unique name |
To bus | Receiving bus | |
R (pu) | Series resistance | p.u. (network base) |
X (pu) | Series reactance (2*pi*f*L) | |
B (pu) | Capacitive charge (2*pi*f*C) |
Available I/O Pins
No | Pin Description | Pin Type | Value/Unit | Instruction |
|---|---|---|---|---|
1 | Set/Get three-phase-to-ground fault | I/O | 1: Active 0: Inactive | lineID/faulty |
2 | Set/Get distance for line fault from starting bus | I/O | 0 < value < 1 | lineID/fault_distance_factor |
3 | Set/Get service status | I/O | 1: In-service | lineID/status |
4 | Get sending end current magnitude | O | p.u. (RMS, network base) | lineID/Imag0 |
5 | Get sending end current angle | O | Degree | lineID/Iang0 |
6 | Get receiving end current magnitude | O | p.u. (RMS, network base) | lineID/Imag1 |
7 | Get receiving end current angle | O | Degree | lineID/Iang1 |
8 | Get sending end active and reactive power | O | p.u. (network base) | lineID/P0 lineID/Q0 |
9 | Get receiving end active and reactive power | O | p.u. (network base) | lineID/P1 lineID/Q1 |
10 | Get active and reactive power loss | O | p.u. (network base) | lineID/PL lineID/QL |
11 | Set/Get resistance, reactance and capacitance of a line | I/O | p.u. (network base) | lineID/resistance lineID/reactance lineID/capacitance |
Example
See the Line page in phasor01_IEEE39.xlsx file in ePHASORSIM example phasor01.
...