Page Content
| Table of Contents |
|---|
...
| minLevel | 1 |
|---|---|
| maxLevel | 7 |
| exclude | Page Content |
Synchronizing with RT-LAB
...
The model simulation status is shown next to the model name. A “Force Refresh” button is also available next to the status, in case the automatic synchronization fails.
...
Running the simulation
The Simulation menu is located in the top-right corner. Clicking on the button will open a dropdown from which you can control the simulation for each model in your project.
...
Running the simulation for multiple models
When starting the simulation for multiple models in a project at once, they will be launched sequentially. Frequent status updates will let you know when a model is waiting to load, loading, or running.
...
Saving the changes made during a simulation
When the stop button is pressed, you will be asked whether you would like to “Discard” or “Save” the edited parameter values during a simulation.
...
The “Discard” button will reset all parameter values to the values before the simulation was started.
The “Save” button will keep all of the values you edited during the simulation. It is still possible to revert the value to the default value obtained from RT-LAB later.
...