...
- Voltage is measured between two potential nodes of the circuit.
- Drag and drop a Voltmeter block from the Meters library to your circuit.
- Connect the Voltmeter block to each of the two potential nodes of the circuit.
- By default, the control port of the voltmeter block sends the measured voltage to the CPU model running in HYPERSIM or RT-LAB.
- If you want to send the measured value to analog output, follow the steps described in Adding I/O to an Electrical Circuit.
- If you need to measure voltage between a specific node of the circuit and a node that has been given a specific name, use the Voltmeter node block to do so.
- To add a name to a specific node in the circuit, add an Electrical node block. This node of the circuit can then be used to measure the voltage.
...