...
- LED Label
- PROG/CFG OK:
- CFG OK steady on greenand PROG off indicates the FPGA is functioning normally.
- CFG OK off and PROG steady on yellowindicate the FPGA has stopped and is no longer functioning.
- RX: Green when receiving synchronization.
- TX: Green when transmitting synchronization.
- USER 1: Green LED controlled. Configured by the user using Simulink blocks.
- USER 2: Green LED controlled. Configured by the user using Simulink blocks.
- PWR ON: Green indicates that the power is on.
- MASTER/SLAVE:
- Green indicates MASTER mode.
- Yellowindicates SLAVE mode.
- Flashing green and yellow indicates a SAFE bitstream in the FPGA
- PROG/CFG OK:
- Dip switch
- CHASSIS INDEX: 8-pin DIP switch that allows users to set the device’s network chassis index. It can be set from 00 to FF (in HEX) for a maximum of 256 addresses, default value = 00. Refer to /wiki/spaces/RD/pages/45897156 General Configuration to copy this value as the Chassis ID value in RT-LAB and HYPERSIM.
- SYNCHRO Connectors Label
- TX/RX Fiber-Optic Connectors (square connectors): Compatible with OP45##, OP46##, OP56##, OP57##, OP7000 and OP7020. Synchronizes time steps between systems and includes high-speed FPGA pulses.
- TX/RXCopper Cable Connectors (3.5 mm audio jack connectors): Legacy connectors compatible with all OPAL-RT products except OP4200, OP5705, OP5650.
...