Page Content

...

The Inner Control Loop block generates the reference control signal for the Reference Generation Block in the d-q coordinate. The inner Control Loop block responds according to the angular frequency, phase angle, and magnitude of the virtual voltage source set by the outer control loop. Two inner control loop structures for grid forming (GFM) converter, i.e., single-loop control and Double-loop control, have been included in the Inner Control Loop block. The fundamental difference between the single-loop and the Double-loop control structure is that the former controls the angular frequency and magnitude of the inverter’s virtual internal voltage source, whereas the latter controls the angular frequency and the magnitude of the filter’s capacitor voltage. Another crucial difference is that Single-loop control includes only the voltage control loop, whereas Double-loop control includes both the voltage and current control loops.  Due to the absence of a current control loop, Single Loop Control may flow excessive current during larger disturbances. Virtual impedance has been integrated with the Single Loop Control approach to limit the current flow. On the contrary, Double Loop Control adopts the Current saturation technique to limit the current flow.

Description

The Inner Control Loop contains two conventionally adopted Inner Control Loop approaches, i.e., single-loop control and Double-Loop Control. Brief descriptions of the adopted Inner Control Loop approaches are as follows.

Single Loop Control

This Inner Loop Control approach adopts only a voltage feedback loop; no current feedback loop is present here. The control architecture of the single-loop control is shown below.

...

Due to the absence of current feedback control, this control loop tends to flow excessive current during larger disturbances. To limit the current flow, virtual impedance has been integrated with the single loop control. A short description of the adopted virtual impedance method is given below.

Virtual Impedance

When a fault occurs, the impedance seen by the grid-forming inverter suddenly decreases. Due to the voltage source behavior of the GFM inverter, it tries to control the voltage at its pre-fault reference. However, a decrease in the impedance forces the inverter to export more current to maintain the pre-fault voltage. But, this excess current must be limited for the safety of the power electronic switches. Since the cause of this increased current is the voltage reference, one way to limit the currents is to decrease the voltage reference. The reference can be decreased by emulating a voltage drop across a virtual impedance. In this block, a virtual resistance has been modeled to increase the damping of the control system instead of the virtual impedance [1]. This is done by the control structure shown below.

...

--uriencoded--$V%5e*_q = V%5e*_t_q-(I_o_dR_V_I+I_o_qX_V_I)$

Double Loop Control

This Inner Loop Control approach adopts both voltage and current feedback control loops. The Double-loop control architecture of the Inner Control Loop is shown below.

...

The current feedback loop adopts a current saturation technique to constrain the current flow; hence, this Inner control loop technique poses inherent protection against overcurrent during larger disturbances.  

Comparison between the Inner Control Loop Methods

For similar filter settings, the grid-forming inverter poses a larger small-signal stability boundary when using the single-loop structure as the inner loop. This difference can be attributed to the different values of the coupling reactance of the two control strategies. Since the single-loop control structure regulates the inner voltage of the inverter, the coupling reactance between the inverter and the grid is larger than the Double-loop structure, which regulates the voltage of the filter’s capacitor. However, one major drawback of the single-loop inner control is the lack of current controllability. This can result in overcurrent tripping of the inverter during short circuits [2]. In the Double-loop control structure, on the other hand, the inverter's output current can be directly limited due to the existence of the current references.

Mask and Parameters

...

Mask Parameters vary with the selection of Inner Control Loop Type. For Single Loop Inner Control Loop, following information are required by the configuration mask of the Inner Control Loop block.

...

Inputs, Outputs, and Signals Available for Monitoring

Inputs

Outputs

References

Intellectual Property Disclaimer

Natural Resources Canada owns all intellectual property rights in the Smart Inverter Modelling Toolbox software and related products.