Page Content
| Table of Contents | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
The OP8320-2 can be installed on a DB37 cable connected to analog output signals coming from the OPAL-RT simulator.
The purpose of this board is to provide user-adjustable custom filtering to these signals.
...
RC/LC Filter
An RC or LC filter can be added for each channel, depending on the frequency cut-out required.
Two sockets are used for this purpose:
The socket represented by a capacitor on the PCB (labeled C below) is used to install the capacitor C2 of the filter.
The socket represented by a resistor (labeled R below) is used to install either the resistor or inductor R2 of the filter.
...
The following parameters are a good starting point for the RC values: R = 10Ω10 Ω, C = 1000pF1000 pF. Choose the appropriate resistor or capacitor to achieve proper tuning, depending on application parameters.
| Background Color | ||
|---|---|---|
| ||
| Info | ||
The OP8320-2 is equipped, by default, with a pre-soldered snubber with the following RC values: R=10Ω, C = 1000pF1000 pF. |
Voltage Divider
Tow resistors can also be used to create a voltage divider if a resistor is installed in the C socket instead of a capacitor.
...