Page Content

...

The “SC_Offline_User_Interface” subsystem consists of three areas, as shown in figure 2.

• The green area (dynamometer Control) send the reference to the dynamometer.

• The yellowarea (Signal Monitoring) is used for receiving and monitoring data from the OPAL-RT simulator.

• The orange area (Instruction) provides important information about the model and its test procedure.

...

• Launch RT-LAB.

• Import project zip file (see below) in RT-LAB.

• Build, load, and execute the model.

• Turn on the 8540 dynamometer and, through its touch panel, enable its “Computer-Based Control,” as depicted in figure 5 below.
  In this operating mode, the user can monitor the state of the dynamometer: torque, speed (frequency), current, and voltage.

...

Based on the preceding tests, the hardware and software included in Festo’s models are declared fully functional and compliant with OPAL-RT specifications.

Anchor
model model

Model (Zip File)

...