Library

ARTEMiS/Tools/POW faults

Blocks

...

Description

The POW fault blocks are blocks used to conduct faults tests on ARTEMiS-SSN models.

...

Please study the following ARTEMiS-SSN demos to quickly master how to use these blocks:

• ssn_distributiongrid_A1.mdl

• ssn_distributiongrid_A2.mdl

OpPOWFaultControl

Mask

...

Parameters

Sample time (s): the sample time used in the block.

...

OpElectricFaultSelector

Mask

...

Block parameters:

Fault type: Use the check boxes to configure the fault type.

...

Fault location ID: The location ID of the fault to be triggered. For a fault to be triggered, the location ID in the OpElectricalFault block must match Fault location ID of this block.

Initial Delay of Fault (sec): the faults will be disabled until this simulation time is reached. In fooline offline simulation, this is useful to let the simulation reach steady-state before the first fault is applied.

...

This block output the fault parameters and the fault location data. This signal is to be fed to the various OpElectricFault blocks.

OpElectricalFault

Mask

...

Parameters:

Fault location ID: use this parameter to specify the ID of the OpElectricalFault block. The fault will be triggered when the ID selected in the OpElectricalFaultSelector block corresponds to the block ID.

...