...
| ControllerName | Bind this block to an OpCtrl block by entering the same 'Controller Name' as specified in the OpCtrl block. The OpCtrl block controls the initialization of the settings of one specific FPGA in the system. |
|---|---|
| DataOut port number | Enter the index of the DataOut port to be controlled by this block, in the range range [1:64] for the VC707, TE0741 and TE0741 OP48xx FPGAs and [1:32] for all others |
| Slot infos | This non-editable parameter displays the physical location of the analog input channels related to the selected DataOut port, as obtained from the parsing of the configuration file. |
| Calibration Mode | When this checkbox is selected, the mask parameters used in the Resolver In block are available as block inputs. This mode allows the tuning of parameters during execution. |
| Damping factor (Ksi) | This parameter specifies the filter's damping factor. |
| Natural Frequency (w0) | This parameter specifies the filter's natural frequency. The unit is Hertz (Hz). |
| Use internal carrier for demodulation | When selected, the Resolver In block generates its own carrier for demodulation. |
| Internal Carrier Delay | This parameter is the delay for the application of the internal carrier with the resolved signals (sine and cosine). It should be between 0 and 20e-6. This input is expressed in seconds. |
| Internal Carrier Frequency | This parameter specifies the carrier frequency. It should be between 0.01 and 90000 Hz. |
| Internal Carrier Amplitude | This parameter specifies the amplitude of the carrier that will be outputted by the Resolver In block. It should be between 0 and 16 V. The resolution is 1 mV. |
| Internal Carrier Offset | This parameter specifies the offset of the carrier that will be outputted by the Resolver In block. It should be between -16 V and 16 V. The resolution is 1 mV. |
| External Carrier Amplitude | This parameter specifies the amplitude of the carrier expected by the Resolver In block. It should be between 0 and 16 V. The resolution is 1 mV. |
| External Carrier Offset | This parameter specifies the offset of the carrier expected by the Resolver In block. It should be between -16 V and 16 V. The resolution is 1 mV. |
| Sine Amplitude (V) | This parameter specifies the amplitude of the resolved sine signal. It should be between 0 and 16 V. The resolution is 1 mV. |
| Sine Offset | This parameter specifies the offset of the resolved sine signal. It should be between -16 V and 16 V. The resolution is 1 mV. |
| Cosine Amplitude | This parameter specifies the amplitude of the resolved cosine signal. It should be between 0 and 16 V. The resolution is 1 mV. |
| Cosine Offset | This parameter specifies the offset of the resolved cosine signal. It should be between -16 V and 16 V. The resolution is 1 mV. |
...