Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The steps required to flash the .hex file of a controller model on the OP8666 are as follows:1-   

  1. Connect the OP8666 to the host computer via the ICP connection port in the front panel.

...

  1. Open UniFlash. A similar screen display as Figure 2 should appear.

...

  1. Select the appropriate TI Controller as shown in Figure 3.

...

  1. After selecting the controller, click on Start (see Figure 4).

...

  1. Browse the .hex file of the controller model to be loaded, as presented in Figure 5.

...

  1. Click on Load Image in order to load the selected file on the controller module (see Figure 6).

...

  1. If loaded successfully, a similar message as presented in Figure 7 will be displayed.

...

...