OP4512 Standard Configuration
A. DB37 connectors for digital or analog inputs and outputs.
B. In the standard OP4512 configuration, this section contains a DB9 connector module for RS422 signals typically used to transmit differential encoder inputs and outputs, however, other options are available.
See OP4512 I/O Expansion Options below for detailed information on available configuration options.
C. Standard computer connectors (from left to right):
1 Serial Port (COM1)
1 IPMI LAN port
2 USB port 2.0
2 USB port 3.0
2 network Gigabit Ethernet RJ-45 Ports
1 VGA Port
Unit Identifier (UID) switch
D. 1 PCIe free slots are available for optional I/O card. See OP4512 PCIe optional I/O cards below.
OP4512 I/O Expansion Options
The OP4512 comes with an RS-422 Connector Kit (OP5969-1) factory installed by default.
The optional Fiber-Optic Connector Kit (OP5969-2) can also be installed. It will replace the default connector kit, since only ONE of these connector kits can be installed in an OP4512 at a time.
The optional connector kit must be selected at the time of purchase and factory-installed.
If the OP3811 or the OP3812 GPS Synchronization Connectors PCIe I/O cards are ordered, none of the following expansion options can be installed because the I/O cards also require a connector plate to be installed in the same location.
RS422 Connector kit |  | DEFAULT connector kit installed |
|---|---|---|
Fiber-Optic Connector kit |  | Optional connector kit |
OP4512 PCIe Optional I/O cards
There are several PCIe options available for the OP4512.
Only ONE of the I/O cards may be installed in an OP4512 at a time.
The PCIe optional I/O card must be selected at the time of purchase and factory-installed.
OP5451 |  | Passive/active PCIe expansion with standard PCIe iPass x4 connector interface. This option is used to connect the OP4512 to an OPAL-RT expansion I/O chassis. The option comes as a kit, including a copper cable.
|
|---|