Documentation Home Page Power Electronics Add-On for NI VeriStand Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

This tutorial describes how to configure the OPAL-RT Power Electronics Add-On to simulate a grid-tied SCIM drive and machine with a closed-loop controller.   We will discuss deploying, running, and monitoring the simulation in real-time. 

Error rendering macro 'excerpt-include' : No link could be created for '1. Three Phase Rectifier'.

The eHS circuit model used in this example was created using the  Simscape Electrical Specialized Power Systems Simulink Blockset. It represents a grid-tied, three-phase diode rectifier for charging the DC Link, as well as a two-Level, three-phase universal bridge.  The bridge is electrically connected to the SCIM model through the project configuration. We generate three sine waves using the built-in FPGA signal generators to simulate the Va_in, Vb_in, and Vc_in AC sources in the electrical circuit. The universal bridge gates in the Inverter block are controlled using signals from the on-board SPWM generators. The SCIM calculated currents are fed back to the universal bridge through the current sources Ia_pmsm and Ib_pmsm.  Nominal operating speeds of the example SCIM are between 1500 and 4000 RPM. 


The tutorial has been split into the following sections:


  • No labels