5.3 Configuring the Electrical Models

The circuit model file has been loaded into the example project already, although the steps below can be used to reload the circuit model.  This is typically only necessary if the circuit has been modified.  For more information, please refer to How to Add a Circuit Model to the System Definition.

• In the Configuration Tree, under Power Electronics Add-On, click Circuit Model.

• In the configuration page, Browse for the Circuit Model File Path.

• Select the model (.mdl) file at the Circuit Model File Path shown below. This automatically triggers a model update in the System Definition. 

• Wait for the update to complete.

• (optional) Click the Refresh button to see additional model information.

• Click Save.

Circuit Model File Path: <Public Documents>\National Instruments\<NI VeriStand 20XX>\Examples\OPAL-RT\Power Electronics Add-On\SCIM Constant Local Control\Circuit Model\SCIM_eHS_UB.mdl

Configuring the SCIM Model

In this example, the SCIM model has been pre-configured. For more information about machine configuration, please refer to the IM SM Section. Explore the machine configuration described below.

• In the Configuration Tree, expand Circuit Model >> Machines and click SCIM 1 to open the configuration page for the machine.

• Observe the configured machine parameters. The Input Mapping subsection allows the outputs of the circuit model to be connected to the inputs of the machine.

• In the Configuration tree, expand SCIM 1 and click Mechanical Model to view the mechanical model parameters.

• Confirm that the parameter values match those in the table below.