Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

The OP8320-2 can be installed on a DB37 cable connected to analog output signals coming from the OPAL-RT simulator. The purpose of this board is to provide user-adjustable custom filtering to these signals.

OP8320-2 Board Interface

RC/LC Filter

An RC or LC filter can be added for each channel, depending on the frequency cut-out required.

Two sockets are used for this purpose:

  1. The socket represented by a capacitor on the PCB (labeled C below) is used to install the capacitor C2 of the filter.
  2. The socket represented by a resistor (labeled R below) is used to install either the resistor or inductor R2 of the filter.

The following parameters are a good starting point for the RC values: R=10Ω, C = 1000pF. Choose the appropriate resistor or capacitor to achieve proper tuning, depending on application parameters.


The OP8320-2 is equipped, by default, with a pre-soldered snubber with the following RC values: R=10Ω, C = 1000pF.



Voltage Divider

Tow resistors can also be used to create a voltage divider if a resistor is installed in the C socket instead of a capacitor.

Example of Voltage Divider for OP8320-2

  • No labels