Example 4: Executing an Existing Project (HYPERSIM <6.2)

In versions of HYPERSIM prior to 6.2, the following steps needed to be done. In HYPERSIM 6.2, those steps are not necessary.

1. Open the model (the copy in bank->hnk) and run it on the desired target.
2. Launch TestView
3. Open the TestView Project
4. Open the test to execute, change the username in the Windows Test block of the test

HYPERSIM Test Block - Change the Username

1. Press ‘Import HYPERSIM (network and sensors)’ and then ‘load Preferences from HYPERSIM’ in the HYPERSIM Settings block of the test.
2. If there are other tests in the project, the steps 4 and 5 need to be repeated for every test.
3. Run the test sequence.