HIL2GO-310 - OPAL-RT Controller Configuration

To use OPAL-RT I/O modules, an OpCtrl block is required in the RT-LAB model.
This block controls the programming of one OPAL-RT FPGA, its initialization and the selection of the hardware synchronization mode of the card.
It also enables binding of Send/Recv and I/O blocks to that specific card.

The OpCtrl block can be found in the Simulink block library path:

RT-LAB I/O > Opal-RT > Common > OpCtrl

The block parameters for the OpCtrl block are already set as follows.

This information is provided for reference, mostly for advanced users. Most users will want to use it “as is.”

OPAL-RT controller parameters
Parameter	Value
Controller Name	'OP4810 OpCtrl'
Board ID (Chassis ID)	0
Primary Bitstream FileName	OP5145_1-EX-0001-3_6_0_818-AIO_DIO_TSDIO_PWMIO_QElO-02-0B
Configuration Number	-1
Synchronization mode	Master
Generate External Clock	☐ (Unchecked)
Sample Time (s)	0
Board Type	OP48xx
Synchronization type	Optical
IP address	192.168.3.5
Chassis Name	OP4810-IO
Synchronization type	Optical fiber
Disable strict hardware mismatch validation	☐ (Unchecked)

I/O signals used in the model will be active ONLY if the model is run in Hardware synchronized mode.