Documentation Home Page ◇ Power Electronics Add-On for NI VeriStand Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

1.4 Configuring the Sources of the Model

Owned by Sylvain Ménard
Last updated: Aug 29, 2023 by Pierre-Luc Renault (Unlicensed)
1 min read

Next, we will route a signal to each source in the circuit model. For more information about the circuit model sources, please refer to the Sources section.

  • In the Configuration Tree, expand Circuit Model >> Sources. Note that a VeriStand channel has been created for each Source component in the circuit model.

  • Click the Sources section to open the configuration page.

  • Confirm that the source mappings are configured as shown in the image below.

  • Click Save.

The outputs of three Sine Wave Generators (SWG00, SWG01, SWG02) are routed to the Sources of the circuit model (Va, Vb, Vc).

 



OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323