...
| ControllerName | Bind this block to an OpCtrl block by entering the same 'Controller Name' as specified in the OpCtrl block The OpCtrl block controls initialization of the settings of one specific FPGA card in the system.ah |
|---|---|
| DataIn port number | Enter the number of the DataIn port to be controlled by this block, in the range [1:64] for the VC707, TE0741 and TE0741 OP48xx FPGAs and [1:32] for all others. |
| Slot infos | This non-editable parameter displays the physical location of the digital output channels related to the selected DataIn port, as obtained from the parsing of the configuration file. |
| Maximum number of DOut channels controlled by this block | This non-editable parameter displays the number of channels in one sub-section listed in the configuration file. |
| Number of DOut channels | Enter the number of channels for which data values will be transmitted at each calculation step. This number must be less than or equal to the value of the 'Maximum number of DOut channels' parameter. The data transfer mechanism between RT-LAB and the FPGA card does not allow the selection of individual channels in the sub-section of channels. The data supplied by the block will thus apply to the N first channels of the sub-section, where N is the value of the 'Number of DOut channels' parameter. |
...