...
Page Content
| Table of Contents | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
At start up, the simulator panel appears, as shown in Figure.2. The default values for the switches, explained in Table 3, are in grey fields.
| Anchor | ||||
|---|---|---|---|---|
|
...
3.2 Tables for Parameters Setup and Control Switches
...
Tab | Oscilloscopes | Waveforms displayed on the oscilloscopes |
Display1 | Oscilloscope 1 | “Generator mechanical angle (degree)”. Mechanical angle of the generator delta in degrees. |
Oscilloscope 2 | “BUS 4 magnitude voltage (pu)”. Voltage magnitude in pu of phase a A on bus 4. | |
y-axis scale | Setting the y-axis scale on the oscilloscope displaying the rotor mechanical angle. | |
y-axis offset | Setting y-axis offset on the oscilloscope displaying the rotor mechanical angle. | |
Display 2 | Oscilloscope 1 | “Generator mechanical angle (degree)”. Generator mechanical angle delta in degrees for 6 seconds, when a fault occurs and trigger “Trig-Acq.Gr. 2” is active. |
Oscilloscope 2 | “BUS 4 magnitude voltage (pu)”. Voltage magnitude in pu of phase a A on bus 4 over a period of 6 seconds when a fault occurs and trigger “Trig-Acq.Gr. 2” is active. | |
y-axis scale | Setting the y-axis scale on the oscilloscope displaying the rotor mechanical angle | |
y-axis offset | Setting the y-axis offset on the oscilloscope displaying the rotor mechanical angle. | |
delta_file | File number for delta angle data saved during fault. | |
voltage_file | File number for bus 4 voltage data saved during fault. |
...