Page Content

...

The OP5020XG can be installed in a 19'' rack.
Normally, the rack mount brackets and handles are assembled to the chassis.

Expand

title	🔴 If brackets and handles are delivered as a separate kit, follow this procedure to assemble the mounting brackets with handles to the simulator.

Hardware List

The hardware for the rack mount brackets and handles are provided in a plastic bag.

Follow these simple steps to install the brackets and the handles.
For each side:

Remove the two (2) top front screws.
- Put the screws away, they will be replaced with longer ones.
Assemble each rack mount bracket using 4 screws.
- Do not use the screws you removed in the previous steps, they are too short.
- 4 screws per bracket, 6-32 x 5/16" flat head, Phillips, OPAL-RT P/N T00-1402
Assemble the handle to the bracket using two (2) screws.
2 screws per handle, 8-32 x ½" flat head, Phillips, OPAL-RT P/N T00-6800

...

Connect the power cord to the unit and to the appropriate power source (outlet).
Connect the Ethernet cable to the leftmost bottom network port
OPTIONAL: Connect one end of a PCIe cable to the PCIe Host adapter. The other end is connected to another unit, most likely an FPGA processor and I/O expansion unit.
Turn on the main power switch in the back.

Note

Make sure that all cables are properly connected before powering up.

Make sure that the main power switch at the rear of the unit is easily accessible for emergency shutdown.

To turn on the simulator, press the front On/Off Button.

...