...
- Added support for MATLAB R2022b
- Added support of Windows 11
- Added support for the pre-release version of OPAL-RT Dashboards
- Added Impedance Measurement tool
- Added Network Lines and Cables Models:
- Added Network Loads Models:
- Added a method to set expressions containing commas via the Python API setComponentParameter
- Added the following Python API commands:
- setPinPhaseNumber
- setProperty: additional parameter to save preferences
- Added timing information in the .simout log in debug mode
- Added warning in Target Manager and when starting the simulation using legacy RedHat and CentOS targets
- Added the possibility of sorting components by numbers in the netlist
- Added Software Compatibility Matrix in the documentation
- Added error message when the user creates a new design with prohibited characters
...
- Improved Renewable Energy example model with native components instead of UCM for controls:
- Improved FPGA Scope workflow by adding a target network configuration in the Target Manager, see Quick Start | FPGA Scope for more information
- Improved User Manual accessibility by adding a dropdown to choose what documentation to open between HYPERSIM, Dashboards, and Schematic Editor
- Improved error message when starting the simulation and the hy.core process is down
- Improved license request process
...
- Improved NIC field to make it case-insensitive
C37.118 Slave
- Added the possibility to apply an offset on the timestamp received
- Added an error message when the Ethernet interface does not exist
...
- Added support for configuring scenarios from the CPU, allowing the definition of a very large number of scenarios, each being applied in multiple CPU time steps
- Added support of Surge Arrester component in eHS Gen5
- Added support of chassis OP4512 and OP4610 with new firmware
- Added documentation for solver settings
- Added a progress bar when the eHS circuit analysis is long (e.g. with a large number of many scenarios)
- Improved user experience by not analyzing the eHS circuit if no changes were done
- Fixed HYPERSIM starting simulation error without opening eHS component
- Fixed DI signal reverse issue for eHS Gen5 on Kintex-7 410T FPGA
- Fixed issue with single switches in Gen4 always using default values for Ron and Roff
- Removed internal source as set parameter
...