Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

From the time the simulation is executed, the signals acquired by the FPGA Scope can be visualized in ScopeView following this procedure:

  1. Make sure Dashboards option is activated in the Preferences view.

  2. From HYPERSIM, open ScopeView (see HYPERSIM Ribbon Options)

  3. In ScopeView, load the Data Source by selecting the simulator IP address into the "Target" field of the FPGA Scope tab, then click the refresh button. Once selected, press "Load".

  4. In the signal selection interface, select the signals to be visualized.

  5. In the ScopeView oscilloscope interface, configure the trigger if required. Adjust the acquisition period and window size, trigger characteristics, and then run an acquisition by clicking the black "Start" button.

...