Sinewave Generators
Next, we can configure the Sinewave Generators used in the simulation. In the Configuration Tree, expand Circuit Model >> Sinewave Generators Configure the Sinewave Generators by confirming that the Default Value of each relevant channel is configured as shown in the table below. Click Save.
Frequency Engines | ||
Channel Name | Default Value | |
---|---|---|
Frequency Engine 0 | 60Hz | |
SWG 0 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 0º | |
SWG 1 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | -120º | |
SWG 2 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 120º |
The default value of the Phase channel of SWG 1 is set to -120. The default values for the other channels listed above can be configured in a similar manner.
SPWM Generators
SPWM Carrier | ||
Channel Name | Default Value | |
---|---|---|
Carrier Frequency | 5000Hz | |
SPWM Generator 0 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 0º | |
SPWM Generator 1 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | -120º | |
SPWM Generator 2 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 120º | |
SPWM Generator 3 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 30º | |
SPWM Generator 4 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | -90º | |
SPWM Generator 5 | ||
Channel Name | Default Value | |
Frequency Engine | 0 | |
Phase | 150º |
The default value of the Phase channel of SPWM Generator 1 is set to -120. The default values for the other channels listed above can be configured in a similar manner.