Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 2
Next »
| A | DB37F I/O connectors (see OP5650XG IO Connectors for more details). |
|---|
| B | Ground Screw. The OP5650XG may be subjected to EMI when it is installed in proximity to other devices. Make sure to connect the OP5650XG ground to the rack to prevent any EMI related damage to the simulator. See OP5650XG Installation and Configuration. |
|---|
| C | Power connector and Power On/Off switch |
|---|
| D | Power reset and 5/12V power source connector for test purposes: - Pushbutton reset after 4A overcurrent shutdown
- Red LED indicates a fault, the green LED indicates a nominal function
- Microfit connector for 5V or 12V power allows users to test whether I/Os are functioning. Each voltage has its own ground reference. Caution: these power sources are not isolated
|
|---|
| E | Optional slots for 2 PCI or 3 PCIe connectors (PCIe only in the lower right slot). |
|---|
| F | 4 SFP ports (for MuSE or device interconnection) and status LEDs for each channel (LED 0 = channel 0, ): - Blinking green: an SFP module is plugged into the port and the bitstream is using Aurora for this channel
- Continuous green: an SFP module is plugged into the port and the bitstream is not using Aurora for this channel
- Blinking red: rx_loss is 1
- Continuous red: tx_fault is 1 (these are SFP status signals)
- OFF: no module plugged into the port and no Aurora present in the bitstream for this channel
|
|---|
| G | |
|---|
