Details on the Overcurrent Model Functionality

The 50P and 50N elements are defined as instantaneous phase overcurrent element and instantaneous neutral overcurrent element, respectively, if the time delay is set to zero.  When setting a non-zero time delay, the element is set as a definite-time overcurrent element. If and only if the measured current becomes larger than the pickup value for a longer duration than the preset time delay, an overcurrent situation is asserted and the relay sends a trip signal through 50P or 50N. Otherwise, the element's internal timer is reset and the relay does not trip.

The time delay and reset mechanism of the 51P and 51N elements are applied similarly.

A tripping signal is sent through 51P or 51N, if the measured current is above the pickup value for a longer duration than a delay time. Both the pickup value and delay time can either be set by the user (custom curves) or determined by the standardized time curves (IEC or US time curves).

If either of the 50P (each phase), 50N, 51P (each phase), and 51N send a tripping signal, the model trips.

50P and 51P modules use the phase current while the operating quantity of 50N and 51N is the zero sequence current which is calculated as the following:

Inverse Time Curve Characteristics

Inverse Time Overcurrent Curves Based on IEC and US Standards

By using a time dial multiplier (TD) and choosing the curve type, the operating and tripping time of the relay can be determined. Setting the multiplier to zero results in instantaneous response to all current levels. The pickup level for 51P and 51N is in per unit. If overcurrent is above the pickup level and custom curves are not being used, then the tripping time is calculated based on this equation.

T = TD * [a/((I/I_pickup)^c-1)+b]

Equation 1: Trip Time Calculation     

The parameters shown in Equation 1 differ based on the curve type. This model has 5 curve types from the US standard and 5 from the IEC standard as shown in the table below. The US standard coefficients are based on the values used by SEL relays and it follows the IEEE C37.112-2018 equation. The IEC curves use the same equation and coefficients stated by the IEC 60255 standard for inverse time overcurrent relays.

The following curve shows the U Series Inverse Curve types.

The next figure shows the C Series Inverse Curve types.

Inverse Time Overcurrent Custom Curves

The custom curve settings for 51X elements have five levels of settings, using five data points. The resulting curve delimits the inverse-time overcurrent operation characteristics using a linear interpolation method between the data points. This means that if an overcurrent scenario occurs and the current measurement is between Level 5 and Level 4, the time delay for such overcurrent level will be linearly calculated between the corresponding Time 5 and Time 4 settings.  The pickup current values and delay times are all tunable parameters. The inverse time overcurrent characteristic of 51P or 51N element is presented in the figure below.

Mask and Parameters

General Parameters

Phase Overcurrent Parameters

Neutral Overcurrent Parameters

Inputs, Outputs and Signals Available for Monitoring

Inputs

Outputs

Sensors

Typical Values for Parameters

The parameter section shows the possible values for each parameter. This section specifies typical values for a few parameters for the custom curves which would be useful as a start to work with the relay model. These values would change to fit the situation of the 50-51 relay model so they cannot be taken as sole values for each parameter.