Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Current »

Available I/O Modules

 Module Model

OPAL-RT Part Number

Description

Max Voltage

OP48H10 Fast I/O Module

410-0685

32 digital channels configurable as inputs or outputs (by groups of 8), 16 analog inputs and 16 analog outputs

DIO: 5 V, AIO 10 V

OP48H20 Standard I/O Module

410-0686

16 digital inputs, 16 digital outputs, 8 analog inputs and up to 24 analog outputs

AIN: ±10 V, AOUT: ±10 V, DIN: 0-30 V, DOUT: 5-30 V

Hardware Platform Compatibility

Module ↓ | Platform→ 

OP4810-IO

OP4815-IO

OP48H10 Fast I/O Module

YES

YES

OP48H20 Standard I/O Module

YES

YES

Calibration

Due to the nature of the electronic circuitry they use, the analog-to-digital and digital-to-analog modules are subject to a slight dispersion of the values they output or measure, as compared to the theoretical values.

To overcome this, the modules are factory-calibrated before being installed on the customer system. This calibration process is used to determine gain and offset parameter values to ensure that the module operates within the prescribed and acceptable range of values, typically with a maximum of ±20 mV around the expected value.

The gain and offset parameters obtained during the calibration process are stored in an EEPROM on the module. They are accessed at power up by the FPGA of the system to which the module is connected, and used during simulation to adjust the output or input values of the modules.

  • No labels