The following section shows the relationship between the I/O blocks in the RT-LAB model and the signal conditioning modules installed on the OP4512 simulator.
They are divided by groups and sections, and each is clearly identified in the illustrations.
The following I/O block mapping is provided with your system. It shows the specific pin assignment on standard DB37 or, DB9 connectors for the system and bitstream delivered.
Nomenclature correspondence between Simulink I/O blocks and OP4512 I/Os | |
Simulink blocks I/O nomenclature | OP4512 I/O ID nomenclature |
Slot | Group |
Module A | A |
Module B | B |
Subsection 1 (SS1) | (0-7) |
Subsection 2 (SS2) | (8-15) |
Subsection 3 (SS3) | (16-23) |
Subsection 4 (SS4) | (24-31) |
The RT-LAB’s Simulink blocks used to access the OP4512 simulator I/Os use the following ID nomenclature:
SlotX.ModuleY.SubSectionZ.
To map the Simulink ID to the physical I/Os in the OP4512 (rear panel), the user is advised to use the nomenclature correspondence in the table above.
For example, in Simulink, Slot1. ModuleA. Subsection3 is equivalent to Group1.A.(16-23) on the OP4512 simulator.
The illustration below shows the arrangement of the subsections of signals for the DB37 and the DB9 connectors.
