Documentation Home Page ◇ HYPERSIM Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

TestView Command | Main | Breaker

Owned by Sylvain Ménard
Last updated: Mar 16, 2023
1 min read

Breaker Dialog Box (Single Param)


This command is used to setup the timings of the breaker(s). If the HYPERSIM network topology has previously been analyzed, all breakers from the model will be available in the dropdown menu in the selection section.


Enable multi-param

When checking this option, the dialog box will change, as shown below. This mode should be used in a loop, because each index represents an iteration.

Breaker Dialog Box (multi-param)


For more information on programming the breakers, look here.



OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323