Block

Mask

Description

The Pulsed Output Module board exhibits the following capabilities:

Converts analog inputs to a digital values
Controls Selection Rails for bipolar and flexible inputs. (the rail selected for standard inputs are set to IGN1 whose the voltage value is set by the Base Module Controller)
Monitor transitions on inputs

Parameters

Some rules must be respected: A controller block and its related functionality blocks must share the same sample time.
Controller Name	The controller name uniquely specified in an OpCtrl block's parameter enables the binding between a specific controller (that has functionalities)and its generic functionalities.
Bipolar0/1 Rail	termination voltage of Bipolar Inputs
Flexible0/1/2/3/4 Rail	termination voltage of Flexible Inputs
Sample Time (s)	This parameter allows the user to specify the sample time for this block, and its associated TestDrive board, in seconds. The default value is 0, which specifies a continuous sample time (note that the sample time is borrowed from the separated subsystem).

Inputs

No input.

Outputs

No input.

Characteristics and Limitations

Synchronization

The synchronization source of the model will be automatically assigned during the load of the model. Any TestDrive card equipped with an OP5142 board can act as a master or a slave.

Connector Pin Assignments

Below are the lists of signals available on the External Elco-56connector sorted by pin numbers.

Direct Feedthrough	Yes
Discrete sample time	Yes
XHP support	Yes
Work offline	Yes

RT-LAB Documentation

OpCtrl Pulse Driven Load Module