Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

OP8E09 Description

The OP8E09 module is designed as a buffer amplifier for four (4) low-voltage inputs signals coming from the unit under test. It also provides global isolation between the unit under test and the simulator.

Features

  • 4 channels

  • Global isolation

  • Individually configurable gain

  • Maximum input range ±16V

Board Layout

OP8E09 - Top view

Channel Description

The gain of each channel can be increased to reach the full ± 16V output range of the OP5340 mezzanine of the simulator by using resistors to adjust R-optional. 

Resistor Settings

An R-optional socket is available for each channel, as shown below. The following table gives with commonly used gains and resistor values to select appropriate resistors.

Gain Adjustment Resistors

Desired Gain (V/V)

RG (Ω)

Nearest 1% RG (Ω)

Desired Gain (V/V)

RG (Ω)

Nearest 1% RG (Ω)

1

NC

NC

2

50.00k

49.9k

5

12.50k

12.4k

10

5.556k

5.62k

20

2.632k

2.61k

50

1.02k

1.02k

100

505.1k

511

200

251.3

249

With the numbers above, by installing, for example, a 5.62KΩ resistor on the R-optional socket, you change the gain from 1 to 10. A ±1.5V input signal will then be seen as a ±15V signal.

Maximum Frequency

The maximum frequency without slew-rate induced distortion is 50KHz

Pin Assignment

Refer to the OP8E00 Modules Pin Assignment table.

OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter