Versions Compared

Old Version 1

changes.mady.by.user Jean-Nicolas Brunet

Saved on

compared with

New Version 2

changes.mady.by.user Jean-Nicolas Brunet

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Fixed an issue where the RT Monitor table was displaying incorrect status in the “Enabled” column when scrolling the table

  • Fixed the Start/stop timeout defined in HYPERSIM (Simulation Settings → Advanced → Simulation Server) that was not always correctly taken into account.

  • Fixed an issue during analyse when a UCM with selected sensors was duplicated.

  • Fixed an issue where the Activation Tool was not responding when applying a license from Help&Support.

  • Fixed an issue where the HYPERSIM engine was crashing when analyzing the network from the Load Flow Viewer.

  • Fixed an issue where the HYPERSIM engine would crash with certain parameter configuration of the 3-winding, w/sat + tap +dec block. The engine would crash when

    • the Vmin parameter was greater than the Vmax parameter, or

    • the Vnom parameter was not between Vmax and Vmin

  • Fixed a HYPERSIM engine crash when a file that is not a .pun was used in line components.

  • Fixed an issue that was slowing down the load flow computation in some cases.

  • Fixed a bug where load flow Load Flow properties weren't being saved when the model was saved.

  • Fixed an issue where the Frequency Protection block was not taking into account the initial value.

  • Fixed an issue where changes to parameters in the Load Flow window were not applied, despite appearing to update visually.

  • Fixed an issue where Line with Line generator did not take the frequency and the ground resistivity into consideration.

Removed

...