Firing (0 = internal, 1 = external, Simulink=2, Control Block=3): Specifies the source of firing pulses;
Simulink:
- Model name: Name of the Simulink model;
- Model directory: Name of the directory in which the Simulink model is stored;
- Execution time: Estimated or measured execution time of the Simulink model.
- UCC command: Always disable (not yet supported).
As a Rectifier:
- KI Id: Integral gain of the PI current regulator (degrees/pu/second);
- KP Id: Proportional gain of the PI current regulator (degrees/pu/second);
- αmin: Lower limit of the delay angle α (degrees);
- αmax: Upper limit of the delay angle α (degrees).
- Δα1, Δα2: Limit values for the positive variation of delay angle α (degrees)) (See Figure 11-11);
- Δα3, Δα4: Limit values for the negative variation of delay angle α (degrees) (See Figure 11-11);
As an inverter:
- KI Id: Integral gain of the PI current regulator (degrees/pu);
- KP Id: Proportional gain of the PI current regulator (degrees/pu);
- KI Vd: Integral gain of the PI voltage regulator (degrees/pu);
- KP Vd: Proportional gain of the PI voltage regulator (degrees/pu);
- γmin: Lower limit for the γ angle (degrees);
- αmin: Lower limit for the α angle (degrees);
- Id Margin: Current margin (pu);
- Vd Margin: Voltage margin (pu);
- Δα1, Δα2: Limit values for the positive variation of delay angle α (degrees) (See Figure 11-11);
- Δα3: Limit value for the negative variation of delay angle α (degrees) (See Figure 11-11);
Synchronization system at firing:
- Synchronization mode (Equidistant, Equiangular): “Equidistant” for equidistant synchronization mode; “Equiangular” for equiangular synchronization mode.
- Vmin: Minimum voltage value at valve terminal, so that the equidistant synchronization mode can fire the valve (pu).
- K osc: Oscillator gain.
- Tap changer transformer with decoupling element: “Enabled”, “Disabled”.
- Transformation ratio, in the event that this last transformer is not used: “Ratio”, where 1.0 (pu) represents the rated ratio Ns/Np.