Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

Faceplate

The faceplate provides two HDB44 connectors (J1, J2), one 4-pin Molex connector (J3), and two LEDs:

J1, J2 Connectors

The 32 digital I/O signals are routed to both J1 and J2 connectors. This allows, for example, splitting the input and output signals into two different cables.

If the harnessing uses only one connector, it is recommended to use J2 (bottom one).

The connectors' pin assignment is detailed in the /wiki/spaces/OICSI/pages/28574364 

J1-J2 Recommended Mating Connector

ManufacturerPart numberDescription
Norcomp180-044-173L000D-SUB Housings
Norcomp180-001-170L001Crimps for 24 to 26 wire gauge
Norcomp979-025-030R121

J3 Connector

J3 is used to connect the two external reference voltages for fault insertion. 

J3 Mating Connector with Crimps

ManufacturerPart numberDescription
Molex538-172258-1004Headers and Wire Housings
Molex538-172253-3023-LPCrimps for 16 to 18 wire gauge

LED Definition

LED NameLED BehaviorDefinition


Power
OffNo power present on module (either from SLSC Interface or external power)
Solid GreenPower OK State
Blinking RedModule Fault State


Ready
OffThe module is not powered or in Rdy/Rst# is driven low by the chassis.
Solid Green

Module in the default configuration, recognized by the chassis and ready to configure.

(The Rdy/Rst# signal has been pulled high by the chassis.)

Blinking AmberThe module is active (in a non-default configuration and/or communicating
with the chassis).
  • No labels