Installation

The board comes installed with the OP5367 and the FIU relays according to the part number selected.

If the board did not come already installed in the NI SLSC-12001 Platform, simply position the module in alignment with the desired slot and push in firmly until the back connectors are pressed into the backplane connectors of the chassis.

Ouptut Voltage Selection

It is possible to select the output voltage of all channels for +3.3V (LVTTL) or +5.0V (TTL) operation via a dipswitch installed on the OP5367.

Make sure the SLSC card is powered down before actioning the dipswitch

See the location of the dipswitch in the picture below:

Hardware Products Documentation > OP8910 Installation and Configuration > OP8910_output _voltage_selection.png