DNP3 Slave | Connections

Once the I/O interface has been configured as desired, the user will have to connect points in the model to points in the driver by using the designated HYPERSIM sensors. The driver's connectable points depend on the number of analog and digital inputs and outputs that the slave has.

The following lists the driver connectable points for an input (analog, binary or double bit binary) and an output (analog or binary).

Analog / binary inputs

Connection point	Direction	Description
Analog input X, Binary input X or Double bit binary input X (X being the number of the point in its related configuration list)	From driver to model	Data value

Analog / binary outputs

Analog

Connection point	Direction	Description
Analog output X (X being the number of the point in its related configuration list)	From model to driver	Data value

Binary

If the Operate as trip/close pair parameter is off:

Connection point	Direction	Description
Binary output X (X being the number of the point in its related configuration list)	From model to driver	Data value

If the Operate as trip/close pair parameter is on:

Connection point	Direction	Description
Binary output X trip (X being the number of the point in its related configuration list)	From model to driver	Data value for the 'trip' output
Binary output X close (X being the number of the point in its related configuration list)	From model to driver	Data value for the 'close' output