Description

The standard analog modules, such as the OP5330 and OP5340, that get installed on the front Op7220 of the chassis are designed to operate in ±16V voltage mode. The back slot corresponding to the OP7220 slot can be used for extra analog signals conditioning with the help of the OP78E0 carrier board.

The OP78E0 carrier board is divided into four sections of four channels each for a total of sixteen channels. Each section can accommodate any OP7800 (Type-E) module .

The choice of modules is determined by the module type installed on the OP7220 on the front of the chassis, all four modules must have the same signal direction (input or output).

Analog Output Configuration

When used with an OP5330 analog output converter module, each section of four channels can receive a different analog out module:

Examples of available modules (see the full list in OP8E00 Conditioning Modules - General Information):

• OP8E03, analog to current output
• OP8E01, prototyping analog PCB
• OP8E00, analog passthrough option when no conditioning is required

Analog Input Configuration

When used with an OP5340 analog input converter module, each section of four channels can receive a different analog input module:

Examples of available modules (see the full list in OP8E00 Conditioning Modules - General Information):

• OP8E02, current to analog input
• OP8E04, high voltage input
• OP8E01, prototyping analog PCB
• OP8E00, analog passthrough option when no conditioning is required

Connector Pin Assignments

Specifications