Requirements

RT-LAB, Schematic Editor/Unified Database and the eHS Power Electronics Toolbox must be installed in order to successfully run this example project.

OP5607 OP5707

In that chassis configuration, you must use an external Digital Out to Digital In loopback connection to control the gates. Connect a loopback cable from digital output to digital input on the simulator. This is essential to successfully run the simulation.

OP4512 OP4610

In that chassis configuration, no Digital Out to Digital In loopback is required.

The OP5369 cards supports natively internal Digital Out to Digital In loopback when it’s setup as bi-directional.

If your IO Configuration contains bi-directional OP5369 card, you can always use its internal loopback capability.

Common Internal Documentation

Example Model requirements

Requirements