HIL2GO-100 - Unpack and Verify the Content of the Box

HIL2GO bundle data card entitled “Meet your HIL2GO Bundle.”

IMPORTANT: The bundle data card contains your OPAL-RTLinux login credentials.
Please make a copy of the card and keep the original in a safe place.

OP4512 Compact Entry-Level RCP/HIL FPGA-Based Real-Time Simulator

Refer to HIL2GO-100 - System Overview for hardware installed inside the chassis.

Power cable, 6 feet (1.83 meters)

Power cable compatible to your country’s power socket type.

Network cable, CAT 6, RJ45 connectors, 10 feet (3.05 meters)

Used to connect the simulator to your host computer via the local network, a network switch or direct connection.

Loopback flat ribbon cable IDC40 to DB37M, 2 feet (0.61 meters)

The loopback board and cable can be used to connect anything to a DB37 I/O port of the simulator.

They are also used for testing the analog and digital inputs and outputs in a closed loop using a test model in RT-LAB. In a loopback test, output ports are connected in a closed loop to input ports using the loop back board and cable. Using the test model, output signals are generated by the simulator and read as input signals by the simulator. Details are provided here: Test your System and Load your Bitstream.

Loopback board DB37, 40 positions with Vuser

OP5980-2 diagnostic module, DB37M slim breakout board

These modules enable users to isolate individual pins originating from a DB37 connector, and to test for connections. We provide 4 modules, one for each DB37 connectors used:

• 2 for the digital I/O connectors: group 1, section A, connector P1 and connector P2

• 1 for the analog in connector: group 2, section A, connector P1

• 1 for analog out connector: group 2, section B, connector P1

Flat DB9 cable, male/male, 1 foot (30.48 cm)

For DB9 serial I/Os.

DB9M slim breakout board, male

These modules enable the user to isolate individual pins originating from a DB9 connectors, and to test for connections.

Rack mounting kit

This kit allows mounting the simulator in a 19-inch rack. The kit includes 2 brackets (P/N 110-2655) and 2 screws (P/N T00-1392). For assembly instruction, please refer to this page: OP4512 Installation - Rack Mount Bracket Assembly.