HIL2GO-100 - I/O Group 2, Section B (CH 00-15) - Analog Outputs (OP5330-3)

Connected I/O module is OP5330 - 16 Analog Output at 1 MSPS or 8 Analog Output at 2 MSPS

Before designing cables, OPAL-RT recommends using the guideline Simulator EMC cable recommendations.
Before connecting the cables, make sure that the voltages or other electrical specifications are compatible with OPAL-RT DB37 specifications of I/O module OP5330-3.

Connector P1 Group 2 - Section B - Channel 00 to 15 (Connector P2 underneath is not used)
DB37F Pin	Assignment	DB37F Pin	Assignment
1	+AOUT00	20	GND
2	+AOUT01	21	GND
3	+AOUT02	22	GND
4	+AOUT03	23	GND
5	+AOUT04	24	GND
6	+AOUT05	25	GND
7	+AOUT06	26	GND
8	+AOUT07	27	GND
9	+AOUT08	28	GND
10	+AOUT09	29	GND
11	+AOUT10	30	GND
12	+AOUT11	31	GND
13	+AOUT12	32	GND
14	+AOUT13	33	GND
15	+AOUT14	34	GND
16	+AOUT15	35	GND
17	+12 V*	36	GND
18	Not used	37	Not used
19	Not used

* Internally provided by the simulator. Non-isolated, limited to 400 mA.

Analog Output channels in this bitstream can be reserved by eHS and managed in OPAL-RT Schematic Editor.

ANALOGOUT BLOCK PARAMETERS
Parameters	CH00-07	CH08-15
Controller Name	'OP4512 OpCtrl'
DataIn Port Number	19	20
Number of channels	8	8
Voltage range	[-16 … 16]	[-16 … 16]