Documentation Home Page ◇ Power Electronics Add-On for NI VeriStand Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Known Issues 1.16.0

Owned by Myriam Desranleau
Last updated: Sept 03, 2024 by Pierre-Luc Renault (Unlicensed)
1 min read

  • EFSNITT-788: When the Reset Models Channel is asserted, the models are reset and placed into a paused state, but some outputs of the models retain their last valid value (instead of going back to 0).

  • PEA-133: For frequencies below 1kHz, the PWM Generators produce signals with a frequency error. The observed error is approximately 0.02% for a 100Hz signal, 0.3% for a 10Hz signal, and 2.3% for a 1Hz signal.

  • PEATT-1081: In VeriStand 2024 Q3, error 1003 occurs when a circuit model is loaded. This is due to Known Issue 2798144 in version 2024 Q3 of the LabVIEW Runtime Engine. To resolve this issue, install Patch 1 for the LabVIEW Runtime Engine 2024 Q3:

  1. Close all NI software, including NI VeriStand.

  2. Open the NI Package Manager.

  3. Under the INSTALLED tab, locate the LabVIEW Runtime (64-bit) and confirm its version. If the version shown is ‘2024 Q3' or ‘24.3.0.49385-0+f233,’ then the patch is not installed.

  4. Navigate to the UPDATES tab and select LabVIEW Runtime (64-bit) version ‘2024 Q3 Patch 1’ or ‘24.3.1.4915-0+f2’.

  5. Click Update and reboot the machine when prompted.

 

OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter