Documentation Home Page RT-LAB Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Configuring EXata-CPS to run alongside RT-LAB

Starting from version 2024.2, EXata-CPS may not be configured to be executed automatically by RT-LAB. Please refer to the EXata-CPS documentation to setup EXata and create a RT-LAB model that has the proper I/O interfaces to configure an EXata target and send data to it.

Once with a model which has the proper I/O interfaces to run with EXata-CPS, EXata-GPS GUI can be made to run automatically when executing the model. In order to do that, open the model in RT-LAB and select the “Simulation Tools” tab:

 

image-20240416-193655.png

 

In order to configure EXata-CPS, refer to the bottom right section “EXata CPS Settings”. The following is a table with all settings:



Setting

Description

Setting

Description

Auto-run EXata-CPS simulation

When checked, RT-LAB will launch EXata-CPS GUI when starting the simulation. This will open the interface on your computer the EXata simulation will run along side the RT-LAB simulation.

Close EXata-CPS GUI on stop simulation

When checked, RT-LAB will automatically stop EXata-CPS GUI at the end of the RT-LAB simulation

EXata CPS executable

Path to the executable of EXata-CPS to be used

From JSON

When selected, this option will run the EXata-CPS scenario generated by the RT-LAB I/O interfaces as a json file. Since this file is generated its location cannot be changed. However, once opened, it may be saved as a .config scenario file and be opened later.

From Config (Path)

When selected, this option allows running the EXata-CPS scenario provided as a .config file on the disk. The scenario must be compatible with the I/O interfaces of the model to use this option.

 

OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter