This page explains how to install and configure all the software required to execute a courseware.

Authors

Danielle S. Nasrallah, eng., Ph.D.
Wolf Peter Jean Philippe, Ph.D.
Angelo Chrabieh

List of Figures

Figure 1: RT-LAB installation wizard
Figure 2: ARTEMIS installation wizard
Figure 3: RT-EVENTS installation wizard
Figure 4: TestDrive Installation wizard
Figure 5: Location of the executable file machine_id.exe
Figure 6: Localization of localhost
Figure 7: Deployment of target: localhost
Figure 8: Installation and activation of the license
Figure 9: Launch the MetaController
Figure 10: Unpack the courseware
Figure 11: Reset the model

1. Installation of OPAL-RT Packages

To run OPAL-RT’s courseware, you must start by installing the following four OPAL-RT packages:

RT-LAB v2024.3.2.48
ARTEMIS v7.10.1.21
RT-EVENTS v4.7.8.14
TestDrive v2.9.0.16

1.1 Installation of RT-LAB

Figure 1: RT-LAB installation wizard

1.2 Installation of ARTEMIS

Figure 2: ARTEMIS installation wizard

1.3 Installation of RT-EVENTS

1.4 Installation of TestDrive

This may take around 45 minutes and requires your approval for every component.
Restart your computer at the end of the installation.

2. License Request and Installation

2.1 Request a License

For each PC in which a courseware is going to run, execute the file entitled § machine_id.exe located in: C:\OPAL-RT\RT-LAB\v2024.3.0.21\common\bin as follows:

Retrieve the generated file entitled: machine_id.opal
Send the retrieved files for all the PCs to the courseware team.
A license will be generated for these specific PCs.

2.2 Install a License

Launch RT-LAB and go to the workbench.
Click on Targets, you must see the localhost as shown below:

Double-click on localhost. You will obtain the following on the right side:

Choose the license tab and click on Install as shown below:

3. Running Courseware

Launch the MetaController v2024.3.2.48
You are supposed to obtain the corresponding icon in the taskbar at the bottom of the screen as shown here below the yellow arrow:

Launch TestDrive (a shortcut of TestDrive is created on your desktop during installation)
Click on Unpack
Unpack the selected courseware, for example: Machine_Synchrone.zip as presented below:

Click on OK.
Once you are done with the laboratory session, click on exit, you get the following:

Select “Yes” to reset the model.

References

While every effort has been made to ensure accuracy in this publication, no responsibility can be accepted for errors or omissions.
Data may change, as well as legislation, and you are strongly advised to obtain copies of the most recently issued regulations, standards, and guidelines.
This publication is not intended to form the basis of a contract.

Courseware

Electric Courseware Software Requirements and Setup