Documentation Home Page Hardware Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

OP5650 Rear Connectors

OP5650  rear connectors


ADB37F I/O connectors (see OP5650 IO Connectors for more details).
BGround Screw. The OP5650 may be subjected to EMI when it is installed in proximity to other devices. Make sure to connect the OP5650 ground to the rack to prevent any EMI related damage to the simulator. See OP5650 Installation and Configuration.
CPower connector and Power On/Off switch
D

Power reset and 5/12V power source connector for test purposes:

  • Pushbutton reset after 4A overcurrent shutdown
  • Red LED indicates a fault, the green LED indicates a nominal function
  • Microfit connector for 5V or 12V power allows users to test whether I/Os are functioning. Each voltage has its own ground reference. Caution: these power sources are not isolated
EOptional slots for 2 PCI or 3 PCIe connectors (PCIe only in the lower right slot).
F

4 SFP ports (for MuSE or device interconnection) and status LEDs for each channel (LED 0 = channel 0, ):

  • Blinking green: an SFP module is plugged into the port and the bitstream is using Aurora for this channel
  • Continuous green: an SFP module is plugged into the port and the bitstream is not using Aurora for this channel
  • Blinking red: rx_loss is 1
  • Continuous red: tx_fault is 1 (these are SFP status signals)
  • OFF: no module plugged into the port and no Aurora present in the bitstream for this channel

OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter