Page Content

Synchronizing with RT-LAB

Dashboards automatically synchronizes with RT-LAB as soon as it is launched from RT-LAB, and for as long as it is open and the model is built.

The model simulation status is shown next to the model name. A “Force Refresh” button is also available next to the status, in case the automatic synchronization fails.

Open

Running the simulation

The Simulation menu is located in the top-right corner. Clicking on the button will open a dropdown where you can control the simulation for each model in your project.

Open

Running the simulation for multiple models

When starting the simulation for multiple models in a project at once, they will be launched sequentially. Frequent status updates will let you know when a model is waiting to load, loading, or running.

Saving the changes made during a simulation

When the stop button is pressed, you will be asked whether you would like to “Discard” or “Save” the edited parameter values during a simulation.

The “Discard” button will reset all parameter values to the values before the simulation was started.

The “Save” button will keep all the values you edited during the simulation. It is still possible to revert the value to the default value obtained from RT-LAB later.

By selecting “Remember my choice”, you will avoid being prompted with this modal every time you stop a simulation. To re-enable the modal, go to Menu → Preferences → Simulation.