Documentation Home Page HYPERSIM Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

Quick Start | ScopeView

Summary of Tutorial

This simple tutorial goes through the basic steps on starting with TestView. It uses an example model from HYPERSIM.

Step 1: HYPERSIM start-up

  • Launch HYPERSIM.
  • In File > Options, there is the Open an Example File section. Select any example model. In this tutorial, the model HVAC_500kV_6BUS is used (in Transmission & Distribution).
  • Click Open Example and select a directory of your choice. In this case, a new folder was created in ‘C:\Users\username\Documents\HYPERSIM\’.

Example model used for the tutorial

  • Either keep the default settings or select the desired settings in the HYPERSIM tab -> Simulation Settings section. Refer to the HYPERSIM Ribbon Options if help is required for that step.
  • Load the sensors (.sig) file available in the model directory.

  • Start the simulation.

Step 2: ScopeView Start-Up

To launch ScopeView, in the HYPERSIM tab, click the ScopeView button.

ScopeView start-up

ScopeView launches 2 windows, one to work on the signal processing and the other to visualize the results.

Data visualization window

Step 3: Add Signals to Visualize

When ScopeView opens, it automatically connects to the model in the forefront (in case multiple models are open) and provides a list (by category) of the sensors selected in HYPERSIM. To connect to another model, read this.

  • Click on WES7.Va, WES7.Vb and WES7.Vc. The chosen signals move automatically to the Selected Signals table at the bottom of the window.

  • Switch to the category Lines and Cables, then click on all currents at the WED7 end of the line.

Step 4: Prepare the Template

  • Click on WES7.Va, WES7.Vb and WES7.Vc to select them (selection is displayed with a thick black border).

  • Superimpose the graphs by clicking here:

Note that the order of the signals in the legend follows the order in which all three graphs were selected.

  • Repeat the same operation for the line currents.

  • Hide the sidebar, we won't need it:

  • Open the top bar options:

  • Change the Time Length of the acquisition to 0.2.

  • If you want, save the template.

Step 4: Visualize Simulation Values

  • Start an acquisition and results are displayed.

OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | | +1 514-935-2323