General Cabling

The following diagram and table illustrate the general cabling instructions for an OP8660 that is connected to third-party devices.

OP8660 Connectors

	Connectors	Connector Type	Instructions
A	Inverter 1 and 2 (digital out)	DB9	Use the DB9 cable provided (113-0466) to connect the OP8660 to an *IGBT drive* or other devices that accept 0-5 digital pulses
B	Encoder 1 and 2 (differential digital in)	DB9	Use the DB9 cable provided (113-0668) to connect the OP8660 to a *quadrature encoder* (Max +/15V)
C	Analog inputs	Mini banana jack (2mm)	Use the cables provided (213-0100-0112, white and 213-0100-0113, yellow) to connect to an *analog* device.
D	Analog Outputs	Mini banana jack (2mm)	Use the cables provided (213-0100-0112, white and 213-0100-0113, yellow) to connect to an *analog* device.
E	Digital Inputs	Mini banana jack (2mm)	Use the cables provided (213-0100-0112, white and 213-0100-0113, yellow) to connect to a *digital* device.
F	Digital Outputs	Mini banana jack (2mm)	Use the cables provided (213-0100-0112, white and 213-0100-0113, yellow) to connect to a *digital* device.
G	High Current Measurements	Banana Jack (4mm)	Use the cables provided (211-0302-0009, yellow and 211-0302-0008, blue) to read the current on the channel (serial connection)
H	High Voltage Measurements	Banana Jack (4mm)	Use the cables provided (211-0302-0009, yellow and 211-0302-0008, blue) to read the voltage on the channel (parallel connection)

LabVolt Cabling

The diagram below shows the typical connection of an OP8660 with a LabVolt system. Actual connections may vary. Refer to the system Description document delivered with your system for more information.

Hardware Products Documentation

OP8660 Cabling Instructions

General Cabling

LabVolt Cabling