OP4610-IO Front Connectors

A. Small form-factor pluggable (SFP) module connectors provide four high-speed communication links between other FPGA simulators or third-party devices.
     Each socket controls one communication link.
     SFP transceivers and fiber-optic cables must be selected (and purchased separately) according to the type and speed of the communication protocol.

• Note: MuSE link requires specific SFP transceivers and optical fiber cables:
  • SFP: Avago AFBR-57R5APZ
  • Cable: LC-LC multimode 850 nm optical fiber

B. JTAG connector (for OPAL-RT technicians’ use only).

• Note: JTAG connector is highly sensitive to Electro Static Discharge (ESD). Always leave plastic plug in place when not in use.
  Wear an anti-static wrist strap at all times when using this connector.

C. Synchronization connectors status and user-configurable LEDs, dip switch and synchronization connectors.

• LED Label
  • PROG/CFG OK:
    • CFG OK steady on green and PROG off indicates the FPGA is functioning normally.
    • CFG OK off and PROG steady on yellow indicate the FPGA has stopped and is no longer functioning.
  • RX: Green when receiving synchronization.
  • TX: Green when transmitting synchronization.
  • USER 1: Green LED controlled. Configured by the user using Simulink blocks.
  • USER 2: Green LED controlled. Configured by the user using Simulink blocks.
  • PWR ON: Green indicates that the power is on.
  • MASTER/SLAVE:
    • Green indicates MASTER mode.
    • Yellow indicates SLAVE mode.
    • Flashing green and yellow indicates a SAFE bitstream in the FPGA
• Dip switch
  • CHASSIS INDEX: 8-pin DIP switch that allows users to set the device’s network chassis index. It can be set from 00 to FF (in HEX) for a maximum of 256 addresses, default value = 00. Refer to General Configuration to copy this value as the Chassis ID value in RT-LAB and HYPERSIM.
• SYNCHRO Connectors Label
  • TX/RX Fiber-Optic Connectors (square connectors): Compatible with OP45##, OP46##, OP56##, OP57##, OP7000 and OP7020. Synchronizes time steps between systems and includes high-speed FPGA pulses.
  • TX/RX Copper Cable Connectors (3.5 mm audio jack connectors): Legacy connectors compatible with all OPAL-RT products except OP4200, OP5705, OP5650.

D. Push button with an integrated LED indicator:

• Power On/Off push button
• Integrated LED
  • Green : Unit is On
  • Black (unlit): Unit is Off