Documentation Home Page ◇ HYPERSIM Home Page
Pour la documentation en FRANÇAIS, utilisez l'outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.
Control System Parameters
Reference Parameters
- Vref: Voltage reference (pu) (automatic mode);
- Bref: Susceptance reference (pu/100MVA) (manual mode).
- CLC Mode: (Automatic, Manual)
Operating Mode Parameters
- TCC mode: (On = synchronized firing of the TSC capacitive branches, Off = continuous firing);
- Valve blocking and unblocking: (Deblock = valve firing enabled, Block = valve firing disabled);
Regulation Parameters
- Kp: Proportional gain;
- Ki: Integral gain;
- Pente: Slope of voltage controller (pu/100MVA);
- Hysteresis: (pu/100MVA).
Protection Strategies
- Vmax: Maximum value of primary voltage (pu). Above this value, the static compensator is disabled;
- Vmin_on: Minimum value of primary voltage (pu). Below this value, the static compensator is disabled;
- Vmin_off: Minimum value of primary voltage (pu) required to enable the static compensator.
AC Fault Parameters
- Vac_min: Primary voltage threshold (pu) below which a fault is detected;
- Delay AC fault (s);
- Minimum duration - AC fault (s);
- Delay under voltage: falling edge delay during a specified time interval is applied (s).
Disturbance Parameters
- Disturbance type: Vref or Bref;
- Delta_Vref: Value of step in the voltage reference (pu);
- Delta_Bref: Value of step in the value of the susceptance reference (pu/100MVA);
- Start time: Time when the disturbance is applied (s);
- End time: Time when the disturbance is removed (s).
Adaptive Band-Pass Parameters
- Base frequency (Hz);
- Minimum frequency (Hz);
- Maximum frequency (Hz);
- Bandwidth (Hz).
Power Component Parameters
The parameters of the elements in the compensator power component are the same for all four branches.
General Parameters
- Connections: Y ground; Y floating; Delta.
RLC Element Parameters
- Branch reactor (H);
- Resistance in parallel with branch reactor (Ω)
- Branch resistance (Ω);
- Branch capacitor (F).
Back-to-back Valve Parameters
- Valve resistance when open (Ω);
- Valve resistance when closed (Ω);
- Threshold voltage (V);
- Chopping current (A);
- Snubber resistance (Ω);
- Snubber capacitor (F);
- Reverse break overvoltage (V);
- Forward break overvoltage (V).
OPAL-RT TECHNOLOGIES, Inc. | 1751, rue Richardson, bureau 1060 | Montréal, Québec Canada H3K 1G6 | opal-rt.com | +1 514-935-2323
Follow OPAL-RT: LinkedIn | Facebook | YouTube | X/Twitter