Remove the Old Target from HYPERSIM

Under the HYPERSIM tab in the Tools section, click Targets.

Open

The following screen will appear.

1. Click on Targets in the Target Manager Pane on the left.

2. In the “Targets” list on the right side, right-click the target’s IP address of the old target under Red Hat Linux OS.

3. Select Delete.

Open

Add the New Target

Under the HYPERSIM tab in the Tools section, click Targets.

Select Targets in the left pane:

1. Click the plus sign (“+”) in the top right corner of the Targets pane to add a new target

2. Enter the primary IP address (eth0/eno1) of your target

3. Add a comprehensive description so that you may easily recognize your target

4. When done, click OK

The username and password are required for the first installation, see below for the details.

• Login user: root

• Password: For the default password see the Quick Start Guide accompanying the USB key.

Setup and Test the HYPERSIM installation

To add a target to HYPERSIM on your host PC, to add or update licenses, to load a model and test your updated system, refer to the RT-LAB user manual, especially these sections and pages:

• How to install HOST & TARGET license for HYPERSIM

• HYPERSIM : How to Request a License on Localhost and Target (Simulator)

• Installing HYPERSIM on a Target from Windows

• Step 6: Opening an Example Model, Loading Sensors and Starting a Simulation

To test your updated system, you can use a test model provided with your OP4510 real-time simulator (for example 6-Bus 230 kV HVAC Transmission System as shown below) or run one of your own models.

See also your System Description Document concerning test model.